Announcement

Collapse
No announcement yet.

DIY Sheetmetal MAC11

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • DIY Sheetmetal MAC11

    http://www.thefirearmblog.com/blog/w...ingreplica.jpg

    The prototype shown was built as a non-firing display model with a dummy bolt and barrel for legal reasons, though it perfectly demonstrates how a compact commercial design can be constructed with little more than a drill, angle grinder and welder.

    Another wonderful contribution to American freedom brought us by way of the THEFIREARMBLOG.COM. A downloadable PDF can be obtained here:

    http://www.thefirearmblog.com/blog/2...x-tube-mac-11/

    http://www.mediafire.com/view/b0u3ppwel9aj7ln

  • #2
    Re: DIY Sheetmetal MAC11

    I have a COBRA 9mm M11 I bought way, way back in 96 or there abouts. about a couple years back when I was making PPS-43 drums, I had this notion of making a drum for my M11 using SUMOI drum, but there is no steel mags available that doesn't cost a arms and a leg.

    so I put that on the back burner until I find a steel mag at a reasonable price.

    Comment

    Working...
    X