No announcement yet.

need rollpin help in phoenix

  • Filter
  • Time
  • Show
Clear All
new posts

  • need rollpin help in phoenix

    i need to install a rollpin in an ace stock. i cant even get this thing to start and i dont want to f it up. so where can i go to have this thing installed and for cheap...i already spent too much on it to start with.

    thanks jay

  • #2
    Are you trying to blind pin a folding stock in the open position? I was under the impression that their folding stocks used a removable hinge plate.

    Otherwise, what's the hole diameter and pin diameter?


    • #3
      no it is the fixed stock. what i am attaching is the small oval part to the stock back(the part that you attach to the receiver block) i bought it from a member who didnt mention it was missing the oval part that connects the two tubes and to the reciever block(i had to order it from ace). the holes are drilled by ace and i believe they are 1/8th inch.
      later jay


      • #4
        The bigger ones can be hard. The proper tool is a roll pin starter punch. If you have access to a drill index, perhaps you can ream out the hole a little to make it easier.