DSA Speed Trigger and Robar NP3 Treatment?

[Floyd]

SA58 Speed Trigger Upgrade
Part# LABOR21 $149.95
SA58 Speed Trigger Upgrade provides a shorter, crisper, lighter and improved trigger control without sacrificing safety and reliability. A perfect upgrade for the Three Gun or Action Shooter who requires the utmost speed, as well as safety and accuracy. The trigger pull weight is typically between 3-4.5 lbs., compared to the military 8-12 lbs. Offered on SA58 rifle builds only.

Robar NP3 Surface Treatment Upgrade
Part# NP3 $149.00
non-reflective coating with high lubricity, low friction and a micro hardness of 48-51RCD. NP3 is corrosion and peel resistant and permits firing for longer periods of time between cleanings. Cleaning an NP3 treated surface requires only a soft cloth with no lubrication. For SA58 and DS ZM4 AR Rifle Builds only.

Anybody have these done to their DSA SA58? Is it worth the money?

[paintballmagnet]

The trigger must be new, have not seen anything on these. Sounds good but like many aftermarket FAL parts through the years, I'll have to see how they work long term before I invest in a set. As for the Robar finish, its as good, possbly better than any on the market today. I would suggest you also take a look at MAC's Tough Gun finish also. (Mac's Shootin' Irons, IIRC)

[guncrazy]

If you want a light trigger pull then send your H,T,S, over to moses at the fafiles.com. Cost you about half of what DSarms wants.